Notifications
Clear all

Suddenly display only has some lighted dots. What can be wrong?

 
(@kleewm)
会员

Hi,

I’m quite new to this system.  With a vendor’s help I managed to configure a working display with a Taurus appliance.

It’s been running quite fine for 2yrs.  The blown LED in the panels were taken care off by replacing the whole panel.

Then suddenly, the whole display was off with only a few lighted LEDs on the screen.  The Taurus appliance seems to be working as it is accessible via the portal.

I would most likely be replacing the sending card as it is not likely that all the LED panels would blow at the same time.

Are there any other areas that I should be looking at?

thx!
kenneth

引用
Topic starter 已发布 : 07/05/2021 10:44 上午
(@baiqiuxing)
会员 Administrator

hi:

   what’s the type of Taurus device ?

回复引用
已发布 : 07/05/2021 11:23 上午
(@baiqiuxing)
会员 Administrator

Hi :

    you  can  check  which the firmware program version of Taurus is ?

回复引用
已发布 : 07/05/2021 11:34 上午
(@novastar_support)
会员

Hi Sir

May i know what type of Taurus that you used, you also can contact for help

support@novastar.tech

回复引用
已发布 : 01/06/2021 3:57 下午
Share: